I may mention, as instances of this, that penny, a denomination of the sizes of nails, as a six-penny or a ten-penny nail, though it was employed by Fently two hundred years ago, and has been in constant use ever since, is not to be found in Webster. Language, p. So, can anybody verify the origin of the term tenpenny nail as currently given in our article? Our methodology is to weigh 10 12D, 16D, 20D and 30D nails randomly selected from a paper bag of nails from the local hardware store.
So not a strong correlation, but still vaguely plausible. Perhaps the fact that these are hot dipped gal nails upsets things slightly? Today, the penny system refers specifically to nail length.
For historical reasons, nails are sold both by a number followed by d and less confusingly by length. It's a way to indicate nail length, as you can see in the table below. Pack are excellent in general construction, carpentry and framing applications. The nails are coated for smooth driving and firm holding power. For general construction, carpentry and framing use.
Made of steel. Our 7d nails for bee hives are specially designed for a long life in outdoor conditions. Nail size is more important than you might think when framing interior walls. Nails that are too long or fat are difficult to drive and can split wood, while short or thin nails just don't do the job. These are called d, or "penny," nails. Galvanized and Vinyl Sinkers When toenailing, which means to drive nails at an angle to secure a butt joint, 8d nails are best. Interior framing nails have a vinyl coating to make them easier to drive.
They are known as vinyl sinkers. When doing exterior framing , framers use galvanized nails , which are rust resistant. The 'denarius' was an old Roman coin and as the centuries passed, the abbreviation 'd' eventually became associated with the old British penny.
What about the expression "10 penny nails "? Note: The 'd' means ' penny '. For example, a '10d nail ' is a '10 penny nail '. Size Inches Cm d The rule of thumb with nails 2 points if you get the pun is that you should choose a nail that is three times as long as the thickness of the material you are fastening. This is a reasonable guide most of the time. Flooring nails used to install subfloors also have wider, flat heads — and are usually ring shanked as well — again to lie flat beneath the finished flooring and to provide protection from boards working loose and developing squeaks.
Specialty nails abound. Double-headed, or duplex , nails are used for temporary construction, such as setting scaffolding, where one head allows for the nail to be driven fully into the wood while the second head provides a way of pulling the nail out once the job is completed.
Spring-head roofing nails are used for attaching corrugated roofing. Upholstery nails have wide, domed heads to give furniture a finished look. Some nails are coated, such as sinker nails, to increase pullout resistance. Concrete coatings applied to nail shanks are intended to roughen up the shank surface for a better bite on wood.
Vinyl coatings on nails are intended to melt upon driving and then reharden to improve the nail shank adhesion to the wood. Wood screws have taken some of the market share away from nails owing to the development of powered drivers. Deck construction is one such example where threaded fasteners dominate as the screw provides excellent holding power against wind-borne uplift.
For structural framing work, nails continue to be the preferred fastening method because of their superior shear strength. This article presented a brief discussion of nail dimensions and standard nail sizes.
For more information on related products or processes, consult our other guides or visit the Thomas Supplier Discovery Platform to locate potential sources of supply or view details on specific products.
Guides Share:. Hardware Types of Fastener Threads.
0コメント